|
CHANGZHOU JINGKONG MOOTOR&ELECTRIC APPLIANCE CO.,LTD
|
2 Phase stepper motor drivers 5A 57mm CW250 for NEMA 23 stepper motor
| Place of Origin: | Zhejiang, China (Mainland) |
|
|
| Add to My Favorites | |
| HiSupplier Escrow |
Product Detail
2Phase stepper motor drivers 57mm CW250 for NEMA23 stepper motor
<
2Phase stepper motor drivers 57mm CW250 for NEMA23 stepper motor
- Model Number: CW250
- Phase: 2 Phase
- Motor Height: 57mm
- Power: DC
- Function: Control
- Speed: Low Or High speed
- Usage: Industrial
- DC power input : 20V~60V
- Output current : 05A
- Mircostepping : 1(1.8º),1/8,
- Dimensions:140mm×94mm×45mm
- Weight : < 500g.
2phase stepper motor driver CW250 for NEMA23 stepper motor/ 57mm stepper motor driver,CW250 for engraving machine,CW5045 stepper motor driver, CW230 stepper driver,CW8060 stepper driver.
Characteristics:
- DC power input type20V~60V
- Output current:05A
- Mircostepping:1(1.8º),1/8,
- Protect form : Overheated protect, lock automatic half current ,error connect protect
- Dimensions:140mm×94mm×45mm
- Weight:<500g.
- Working environment:Temperature-1540 Humidity<90%.
I/O Ports:
- VCC+:DC power positive pole
- Note:Must guard against exceeding 40V,so as not to damage the module
- GND:DC power cathode
- A+,A-:Stepping motor one winding
- B+,B-:Stepping motor other winding
5,CP +,CP -:Stepping pulse input+5V (Rising edge effective , rising edge duration >10μS)
6,CW +,CW-:Stepping motor direction input, voltage level touched
off,high towards, low reverse
7,NC:vacant
8,GND:The same to “2”
The interface see
the right picture
NOTE:
1, When ambient temperature is high or working current over 3A, fix the module on big metal shell , or use axle flows fan dispels the heat, to make the module run reliably for a long time.
2, Half current automatically: if control machine not send out signal in half second, driver enter half current state of automatically for electricity saving, the phase current of the winding of the electric
3, The fault phase is protected : When the double-phase electrical machinery is connected with driver , users are apt to connect the phase by mistake, thus would damage the driver seriously. The protecting circuit is within this driver, when users connect by mistake, the driver will not be damaged, but the electrical machinery runs abnormally, shake , and output is small.Please check whether the wiring of electrical machinery is a mistake
Switch Choice: (“ON=0,OFF=1”)
2,Current choice:
